Using scenario editor:
Click State Vectors
Change the coordinates to be polar.
Adjust the radius to the altitude you wish.
Same with the velocity.
You flick coordinate system for velocity
orbiter\vessel\Scriptpb.cfg
It is a luascript implementation. :-)
It's amazing. But I cannot back translate it into a workable config.
I know I can modify/use luascript. Manual says it can be done in config file.
A working example would very help. I have tried to figure it out.
Regards
Lee
Many thanks for your replies. The carina.cfg does contain a minimum configuaration.
A fullyfatted config file would be helpful as a rapid application developement tool? Just one.
The orbiter configuration user manual references these and other definitions that must work in combination...
Does anyone have a full/complete of version of spacecraft configuration file, stored in folder: config .
As described orbiter configuration user manual PDF. Section 2.5
Regards
Lee
Spacecraft configuration files.
Does anyone have a full/complete of version of spacecraft configuration file, stored in folder: config .
As described orbiter configuration user manual PDF. Section 2.5
:)
Regards
Lee
A complete guess. If the LER is just turning on the spot and not moving then
vs2.surf_lat += d_lat*RAD;
vs2.surf_lng += d_lng*RAD;
is setting it to be vs2.surf_hdg inside
DefSetStateEx(&vs2);
The definition of vs2 is different in someway?
Hi Enjo.
Orbiter 171203, XP. It does load. And MFD is visible. There is a small square in the centre of the MFD. The buttons don't seem to influence things. The framerate drops through the floor, so something going on. Turning off the MFD elevates the framerate by a factor of 4.
I hope others...