I re-did the MCC-7 P30 uplink using retrofire, and yes I messed that up originally, as you promised everything went much better after inputting correct data (go figure). A few more questions that cropped up as I went through the re-entry....
On the Entry Checklist pg 1-5, with the system test meter in position 5B my BAT RLY BUS should be 3.4-4.1, I read zero. Am I incorrectly configured or does this not work yet in NASSP?
Concerning the RCS rings: The AOH pg 4-549 has us isolate system 2, with a caveat "omit for hybrid deorbit". On the Entry Checklist pg E1-5 after the RCS check it looks like we leave ring 1 in MNA and ring 2 in MNB, and I can't see where we would turn off ring 2. How was I supposed to correctly configure this?
Finally, approaching EI both FDAIs are showing the same attitude. But during the re-entry as the CM rolls around to control the lift vector, there's a difference between what's displayed on FDAI 1 and FDAI 2. The roll angle seems to be the same on both, but where FDAI 1 pitch and yaw oscillates, FDAI 2 pitch and yaw seems fixed. What's going on here?
Thanks again.