Hi,
am using Base Sync MFD 3.3 (without MMext2.1 installed) from OH here:
Trying to enter target lat. and long. manually but it won't accept any longitude between W90 to W180 (I also tried minus sign prefix).
If I make a base at the required lat/long, and target the base by name, there is no problem.
Just me or can anyone confirm?
Very nice MFD utility, by the way
Thanks,
Brian
am using Base Sync MFD 3.3 (without MMext2.1 installed) from OH here:
Trying to enter target lat. and long. manually but it won't accept any longitude between W90 to W180 (I also tried minus sign prefix).
If I make a base at the required lat/long, and target the base by name, there is no problem.
Just me or can anyone confirm?
Very nice MFD utility, by the way
Thanks,
Brian