General Question General Mission Analysis Tool - Vary Finite Burn Duration

wmunsell

New member
Joined
Feb 4, 2022
Messages
2
Reaction score
0
Points
1
Location
49002
curious to know if anyone could perhaps explain how the parameters are used within the Vary command?
1643995732756.png
i have a finite burn configured that utilizes an electric thruster. if i simply propagate the burn for 2+ days, I can see the increase in Apogee, however, i cant seem to figure out how to properly configure a target Apogee. when i run the above, my BurnDuration variable goes in this order '2, 3, 4, 5, 6, 5, 6, 5, 6'. why is it bouncing between 5 and 6?
 
Top