Update NASSP keyboard commands

indy91

Addon Developer
Addon Developer
Joined
Oct 26, 2011
Messages
961
Reaction score
259
Points
78
Here a list of all the keyboard commands and controls for NASSP 8.0. There was a post like this on the old forum and there recently have been some additions (keyboard commands for the DEDA in the LM). So until there is a proper manual for NASSP 8.0, here a forum post with all the commands.

General Controls:

Divide (Numpad): switch between rotational and translational controls

Rotational Controls:
2 (Numpad): Pitch up
8 (Numpad): Pitch down
1 (Numpad): Yaw left
3 (Numpad): Yaw right
4 (Numpad): Roll left
6 (Numpad): Roll right

Translational Controls:
6 (Numpad): +X (forward)
9 (Numpad): -X (backwards)
2 (Numpad): +Z (Up)
8 (Numpad): -Z (Down)
1 (Numpad): +Y (Left)
2 (Numpad): -Y (Right)

CSM:

W: Optics up
S: Optics down
A: Optics left
D: Optics right
Q: Optics mark
E: Optics reject
V: Change Sextant View Mode to DualView

TAB, 1-9: MCC CAPCOM interface

Shift+Decimal (Numpad): DSKY Clear
Shift+Page Up: DSKY Reset
Shift+Home: DSKY Key Release
Shift+Enter (Numpad): DSKY Enter
Shift+Divide (Numpad): DSKY Verb
Shift+Multiply (Numpad): DSKY Noun
Shift+Add (Numpad): DSKY Plus
Shift+Substract (Numpad): DSKY Minus
Shift+End: DSKY Proceed
Shift+ 0-9 (Numpad): DSKY 0-9

Shift+W: Minimum impulse controller, pitch down
Shift+S: Minimum impulse controller, pitch up
Shift+A: Minimum impulse controller, yaw left
Shift+D: Minimum impulse controller, yaw right
Shift+Q: Minimum impulse controller, roll left
Shift+E: Minimum impulse controller, roll right

LM:

The DSKY and MCC controls are the same as in the CSM.

Ctrl+Decimal (Numpad): DEDA Clear
Ctrl+Enter (Numpad): DEDA Enter
Ctrl+Divide (Numpad): DEDA Hold
Ctrl+Multiply (Numpad): DEDA Read Out
Ctrl+Add (Numpad): DEDA Plus
Ctrl+Subtract (Numpad): DEDA Minus
Ctrl+ 0-9 (Numpad): DEDA 0-9

A: Cycle AOT detent up
D: Cycle AOT deten down
W: AOT reticle up
Alt+W: AOT reticle up (slow rate)
S: AOT reticle down
Alt+S: AOT reticle down (slow rate)
Q: Mark X
Y: Mark Y
E: Reject
Minus: Increase Descent Rate
Equals: Decrease Descent Rate
K: Toggle PGNS mode control AUTO/ATT HOLD
M: Toggle throttle control AUTO/MAN
SHIFT+A: Abort Stage PUSH

Zero (Numpad): Throttle up
Decimal (Numpad): Throttle down
Minus (Numpad): Toggle Engine Stop Button
Plus (Numpad): Depress Engine Start Button
 
Last edited:

CuriousMarc

New member
Joined
Aug 3, 2019
Messages
7
Reaction score
1
Points
0
For some reason I can’t get the Q and Y keys to work for marking in the LM. All the other keys seem to work. Am I doing something wrong?
 

meik84

New member
Joined
Oct 28, 2012
Messages
72
Reaction score
0
Points
0
P52 is quite picky about those buttons, they have to be used alternating, i.e. first X, then Y, then X again and so on. But at least it's fair and tells you which button it wants: V52 is X, V53 is Y and V54 is X or Y (it doesn't matter if you start with X or Y, as long as an X mark is followed by a Y mark and vice versa).
 

CuriousMarc

New member
Joined
Aug 3, 2019
Messages
7
Reaction score
1
Points
0
OK I will try it again. I am a little concern I don't even hear a click. The marking buttons on the LM optics control panel do not seem to respond to mouse clicks either.
 

DDasng1352

Addon Tester
Joined
May 1, 2021
Messages
465
Reaction score
84
Points
28
Location
Los Angeles
Hmm, I think it's the Roll, Pitch, Yaw. I'm having trouble docking with the LM and landing. For some reason I don't have a number pad and joystick.
 

indy91

Addon Developer
Addon Developer
Joined
Oct 26, 2011
Messages
961
Reaction score
259
Points
78
So you can't control CSM or LM at all? Does any other vehicle in Orbiter work?
 
Top