Problem D3D11 client procedure entry point error

[kash01]

hey i just dowloaded D3D11client but when i open orbiter_ng and activate the client in module it give me error

 

[Urwumpe]

hey i just dowloaded D3D11client but when i open orbiter_ng and activate the client in module it give me error

This usually means you are using a module made for a different version of Orbiter than you have installed. In this case, likely:

D3D11client is older than the Orbiter version you installed, since Orbiter is looking for a function that the DLL does not have.

 

[Face]

hey i just dowloaded D3D11client but when i open orbiter_ng and activate the client in module it give me error

D3D11Client is basically abandoned, don't use it.

 

[kash01]

so what should i do? found a version of client that can run on orbiter 2010 if so where can i find it? have been looking for THANKS :thumbup:
EDIT ok if it abbandoned thank i didnt know that