Problem with STS-124 Payloads Pack, traced to Dextre SPDM

[DaveS]

I have recently installed the STS-124 Payloads Pack and have encountered lots of CTDs. Through methodical trial&error, I have traced them to the Dextre SPDM.

I have installed all the pre-requesties mentioned in the STS-124 Payloads Pakc readme namely:

Space Shuttle Ultra 1.06(Replaced this one with the latest dev version)
Vinka's spacecraft3 module
STS-122 and STS-123 addons

If I leave Dextre out of the scenario, it loads just fine. If I put it back in, it's an instant CTD.

Two small cosmetical issues noted:

1)the JPM trunnion pins doesn't line up with the V-guides in the payload bay.
2)The JEM RMS is completely extended when it is supposed to be in a stowed state against the forward end of the JPM.

 

[Donamy]

Use the JEMBAY in the payloadbay.

 

[Opie]

Dont mean to threadjack but is there anything special to get the animations on the JEM? I tried using the keys listed in the documentation but they do not work.

 

[DaveS]

Use the JEMBAY in the payloadbay.

I am. Still doesn't line up with the V-Guides in the bay. And what about Dextre? It seems to have something to do with the the attachments. If I remove the attachments data for the arms in the scenario file, the scenario loads and works, but the arms isn't attached to the Dextre main-body.

Is there anything else I need to install to make Dextre load?

 

[Opie]

The scenarios that David 413 wrote have the correct arm positions for the JEMRMS.

 

[Donamy]

Opie,
Focus on the JEMRMS to use the animations.

Dave,
Which ISS are you using ?

 

[DaveS]

Opie,
Focus on the JEMRMS to use the animations.

By default it should have good numbers for being in the proper stowed state, but the scenarios you provide, it's in the fully extended state, going through the orbiter!

Dave,
Which ISS are you using ?

The one from your ISS Experience V2 add-on. With the Russian vehicles from Mustard's site.

 

[Opie]

Opie,
Focus on the JEMRMS to use the animations.

The animations I am talking about are the ones for the window and airlock. The docs say press k or g, but pressing those keys while focused on the JEM or RMS do nothing. I have no problem doing the arm motions