I'm probably doing something dumb but I can't seem to figure it out on my own. This is on NASSP V8 (most recent beta from GitHub). When attempting to input RPY values into V25N22 for extraction I'm getting an OPR ERR on the DSKY. Honestly I don't even know if I'm inputting the data correctly because all of the documents I've found simply state to input the values without giving the actual steps. Here's the extraction angles from the PAD:
XXX303 R
XXX287 P Extraction
XXX319 Y
On the DSKY I first ensure P00, then:
V25N22E
30300E (I've been assuming I fill in the remainder of the angle with zeros)
28 and as soon as I press the 8 key I get OPR ERR.
I have also tried inserting zeros before the angle (so line one is 00303 and line two is 0028[error]).
What in the world is going on here?
XXX303 R
XXX287 P Extraction
XXX319 Y
On the DSKY I first ensure P00, then:
V25N22E
30300E (I've been assuming I fill in the remainder of the angle with zeros)
28 and as soon as I press the 8 key I get OPR ERR.
I have also tried inserting zeros before the angle (so line one is 00303 and line two is 0028[error]).
What in the world is going on here?
Last edited: