- Joined
- Mar 31, 2008
- Messages
- 147
- Reaction score
- 0
- Points
- 0
- Location
- France, Normandy
- Website
- orbiter.mustard-fr.com
McWgogs, this is the result with your news textures, it' better:
![temp1ax1.jpg](http://img76.imageshack.us/img76/2562/temp1ax1.jpg)
Yes and here's a couple of good photos that shows the blanket box ends of the wings, including the three guide-wires if you look closely:Looking good![]()
can you attach 2 or more panels like the ISS so that there will be 2 pairs at each side of the station?.
I believe roblin already has made the P5/S5 short spacer trusses for his Orbiteer Mission Pack.You think about P5 and P6 Trusses.
Yes i envisage to make P5 (intermediate truss) and P6 (array solar), like the actual ISS, but of course after this project.
I believe roblin already has made the P5/S5 short spacer trusses for his Orbiteer Mission Pack.
True. And P6 being same as P4: not quite. Only the upper part share design, the so called Integrated Electronics Assembly(IEA, where the batteries are located).I prefer make my own P5/S5, because the docking point and dimension can be lightly different. This module is easy to do.
And P6 is juste the same that P4, so the 3d model already exist.
Normally it will be in DLL, with a sun tracking. this DLL will make by Russ H and BJ, which will collaborate in this project for the C++ part.
Thx to them.
After this i will do the module P5, P5 is an intermediate module to attach a new module, solar for exemple. If possible i will do P6 too (similar to P4).