Was this a P00 immediately after the burn? Sounds like your state vector is still integrating. Did you set the surface flag for the LM after jettison (V44)?After the shape burn, when I go to P00 (V37E 00E) I have a steady COMP ACTY light. V96 will get rid of the light, but if I go back to P00 the COMP ACTY comes back on. I don't know what routine might be running, but how do I stop it? Thanks.
You reset it before the shape burn but only after a V66 to put the CSM SV in both slots. If your LM SV was still in there it can cause problems. You can check your SV time with V16 N38 and see where it is compared to your CMC time. If it is far off the easy fix is a V96 and uplinking a new CM SV and V66 and V45 to make sure the surface flag is reset.