Hi,
The scenario instructions (document Pack24En.pdf), states the following:
“For the train (ProtonTrain) the initial position is in the center of the launching pad to the foot of the rocket
.
.
.
.
The rocket can be released by doing Ctrl + Q followed by Shift + 0 on the numeric keypad It can be reloaded if the support is erected against it by performing the same maneuver”
The problem is that the key sequence, Ctrl + Q, suggested to release the rocket from the train is the same one used to exit simulation.
Every time this key sequence is used, instead of releasing the train it simply exits the simulation.
Regards
The scenario instructions (document Pack24En.pdf), states the following:
“For the train (ProtonTrain) the initial position is in the center of the launching pad to the foot of the rocket
.
.
.
.
The rocket can be released by doing Ctrl + Q followed by Shift + 0 on the numeric keypad It can be reloaded if the support is erected against it by performing the same maneuver”
The problem is that the key sequence, Ctrl + Q, suggested to release the rocket from the train is the same one used to exit simulation.
Every time this key sequence is used, instead of releasing the train it simply exits the simulation.
Regards
Last edited: